I agree with all of these comments. 1) Make sure the master switch is not toggled to disable the passenger window. 2) Replace 20A fuse 10 under the dash with a known good fuse. 3) Pull the door panel off and check whether the passenger window motor has battery voltage when the switch is turned on. As for power to the switch, first check fuses (unless you already have) and then throw a multimeter on each wire one at a time - 12V = your inlet power. Sorry I don't have a specific wire to tell you about, but that's what I'd do to check. -Greg. '94 Trooper S - 3.2L V6 DOHC, LSD, 4X4, stock. Reset Procedure 2. If the above reset instructions do not work for your Fusion, then this alternate method may work. Start your Fusion. Close all windows and doors. Open the window by pressing and holding the window control switch. When the window is fully open, keep the switch pressed for a few seconds. 2. Turn the ignition switch to the “ON” position. 3. Open the driver’s side window halfway by pushing down the power window switch. 4. Pull up the power window switch and close the window completely. Continue pulling up the switch for approximately 1 second after the window is closed completely. Only my drivers window switch quit working on the master power window switch panel. All the other switches on that panel still work. After doing some searching I found a video on youtube of a guy taking the passenger switch and moving it to the drivers side to test if the problem is the regulator, or the switch itself. Reset Procedure 2. If the above reset instructions do not work for your Impala, then this alternate method may work. Start your Impala. Close all windows and doors. Open the window by pressing and holding the window control switch. When the window is fully open, keep the switch pressed for a few seconds. Here's what I've done so far: 1. Disconnected the plug to the window regulator and hooked up direct 12V power to the motor. I got nothing which, to me, indicates that the motor is bad. 2. Without a wiring diagram I have no way of telling which wires are the switch. Any suggestions would be greatly appreciated. The passenger window switch gets both power and ground from the master switch. You have replaced the passenger side switch and it still had the same result and if the wiring is good from the master switch to the passenger side switch, then the only thing left would be the power window master switch. Check all wiring of the Master switch. vZQd8.